Building A Fence Gate On A Slope

Install a gate sag kit on the inside of the gate following the specific instructions that come with your kit.

Building a fence gate on a slope.

If i build the gate to look the same as the fence the gates will not be square. In other words my pickets are vertical but the rails are not horizontal. Mimic the 90 degree opening arc with a level set on the 2x4 and either raise or lower the straight edge until the level reads level. Posted july 2011 category.

I want to install a double 5 ft drive through gate in the fence. Stand the gate upright with a 1 inch thick wood spacer under each end between the posts. Bolt the hinges to the fence and remove the spacer. Either make a mark and then measure from the low point on the grade to your mark or measure while holding the straight edge.

Drive a screw into each gate post 3 inches above the ground and tie mason s twine between them. First off if you can avoid installing a gate on a slope do it. I have a slope of about 4 in per 10 feet and am following the contour of the land. This will give you the drop for that particular gate leaf.

This video gives you some tips on how to put up a privacy fence on a sloped piece of land. Installing a gate on a hillside presents quite a few challenges and if it can be avoided try to install the gate in a flat area with as little slope as possible. Test the swing of the gate to be sure it clears. Position the hinges and bore pilot holes through the horizontal rails of the panel on the downhill side of the opening.

Just type lsailor1 in the youtube se.